Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig . A) - Parkside PAEXS 20-Li A1 Originalbetriebsanleitung

■ Avoid sanding lead paint or other harmful
materials .
■ Materials containing asbestos must not be
processed . Asbestos is a known carcinogen .
■ Avoid contact with the sanding sheet while the
appliance is running .
■ Do not use the appliance without a sanding
sheet fitted .
■ Never use the appliance for other purposes and
only use original parts/accessories . Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury .
■ Always allow the appliance to come to a
complete standstill before putting it down .
■ The appliance must always be kept clean,
dry and free from oil or grease .
Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.
WARNING!
■ Do not use any accessories that are not
recommended by PARKSIDE . This can lead to
an electric shock and fire .
PAEXS 20-Li A1

Before use

Charging the battery pack
(see fig . A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed charger
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C .
♦ Plug the battery pack
charger (see fig . A) .
♦ Insert the power plug into the socket . The red
control LED lights up .
♦ The green LED indicates that the charging
process is complete and the battery pack
ready .
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Disconnect the power plug from the mains
power socket . Remove the battery pack
the high-speed charger
♦ Never recharge a battery pack
diately after rapid charging . There is a risk that
the battery pack
reduce the lifespan of the again .
♦ Switch the high-speed charger
15 minutes between successive charging
processes . Also disconnect the power plug from
the mains power socket .
from or connect
into the high-speed
flashes, this means
has overheated and
both
.
again imme-
will overheat, which will
off for at least
GB │ IE │ NI │ 7
.
is
is
from
■