Operation; Charging The Battery Pack; Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder; Reading Off The Battery Status - Parkside PFBS 9.6 A1 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Operation
J
clean, dry and free of oil or grease.
J
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.

Operation

Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.

Charging the battery pack

Q
NOTE! A battery pack that has been
unused for a while or never been charged
must be charged before reuse or first use.
The battery pack requires about 3-5 cycles before
it can reach its full charge. The charging process
takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
you insert the battery pack into or take it out of
the charger.
j
Connect the adapter
j
Insert the battery pack
cradle
correct polarity.
j
The LED
tery pack
the adapter
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
14 GB/IE
Downloaded from www.Manualslib.com
Always keep the device
to a mains socket.
10
into the charging
3 a
. This can only be inserted with the
9
lights up green whenever the bat-
11
is in the charging cradle
3 a
is connected to a mains socket.
10
manuals search engine
Inserting / removing the
Q
battery pack into / out of the
drill / grinder
Inserting the battery pack:
j
Set the ON / OFF switch
j
Insert the battery pack
until it engages.
Removing the battery pack:
j
Pressing the battery pack buttons
sides at the same time allows you to remove
the battery pack

Reading off the battery status

Q
The status or residual power is indicated as follows
in the battery-operated LED
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
Inserting or replacing
Q
a tool / collet
j
Press the spindle lock
j
) before Rotate the clamping nut
10
engages.
j
Loosen the clamping nut
tion key
j
If a tool is already inserted, remove it.
j
First insert the tool you wish to use through the
clamping nut
collet
j
and Press the spindle lock
9
j
Insert the collet
tighten the clamping nut
the combination key
NOTE: Use the screwdriver end of the combi-
nation key
the mandrels
to position "0".
5
into the drill / grinder
3 a
.
3 a
whenever the appli-
2
and keep it pressed.
8
until the lock
6
with the combina-
6
.
23
before you insert it into the
6
suitable for the tool shaft.
18
and keep it pressed.
8
into the threaded insert and
18
on the thread using
6
.
23
to release or tighten the screw of
23
.
13
at the
3