Elcometer MTG6 Gebrauchsanleitung Seite 34

17 SPARES & ACCESSORIES (continued)
17.2 CALIBRATION STANDARDS
Available as a set or individually, allowing
users to select the most appropriate
thicknesses for their application, Elcometer
calibration standards are manufactured
from 4340 steel to a tolerance of ±0.1% of
the nominal thickness.
Calibration standard sets and individual standards are supplied
complete with calibration certificate.
Description
Calibration Standard Set;
Nominal Thickness: 2 - 30mm (0.08 - 1.18")
Comprising of nominal thicknesses; 2, 5, 10, 15, 20, 25 & 30mm
(0.08, 0.20, 0.39, 0.59, 0.79, 0.98 & 1.18") , complete with holder
and calibration certificate.
Calibration Standard Set;
Nominal Thickness: 40 - 100mm (1.57 - 3.94")
Comprising of nominal thicknesses; 40, 50, 60, 70, 80, 90 & 100mm
(1.57, 1.97, 2.36, 2.76, 3.15, 3.54 & 3.94") , complete with holder
and calibration certificate.
Calibration Standard Holder
for thicknesses up to 100mm (3.94")
Note: Elcometer recommends that Calibration Standards are wrapped in anti-
corrosion film when not in use.
f
Calibration standards manufactured in other materials are available on request. Contact Elcometer for
further information.
g
Imperial values for information purposes only. Calibration standards are manufactured and measured in
millimetres.
en-33
R
f
g
g
g
g
g
Sales Part Number
T920CALSTD-SET1
T920CALSTD-SET2
T920CALSTD-HLD
www.elcometer.com