14.4
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as well
as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.5
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
or shuts down during
idle
Machine stops during
operation
Machine vibrates during
operation
Workpiece clamps
during
thicknessing
Bad surface condition
after operating
Rough surface after
operating
Cracked surface after
operating
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
Power supply outage
Damaged or incorrect connected
extension cable
Damaged switch or motor
Blunt blade
Feeding speed to high
Motor protection triggered
Wrong adjusted blade
Ground not flat or base feet wrong
adjusted
Cutting depth to high
Dirty thicknessing table
Blunt blade
Uneven feed of the workpiece
Workpiece too moist
Workpiece was processed against
the direction of growth
Cutting depth to high
www.holzmann-maschinen.at
N O T I C E
Check fuse of the power supply
Check plug or extension cable
Contact customer support
Check blade
Work with lower feeding speed
Let the motor cool down
Check the setting of the blades
Set the base feet correct
Set the correct cutting depth and
operate in more steps
Clean and apply the table surface
with lubricant
Check blade
Feed workpiece evenly and with
constant pressure
Use drier workpiece
Proceed the workpiece in opposite
direction
Set the correct cutting depth and
operate in more steps
N O T I C E
TROUBLE SHOOTING
Solution
39
HOB 410PRO