Cross-Section; Assembly - Holzmann HOB 410PRO Betriebsanleitung

3. If the connector plug doesn't fit or if it is defect, only qualified electricians may modify or
re-new it!
4. The grounding wire should be held in green-yellow.
5. A damaged cable has to be exchanged immediately!
6. Check, whether the feeding voltage and the Hz comply to the required values of the
machine. A deviation of feeding voltage of ±5% is allowed (e.g.: a machine with working
voltage of 380V can work within a voltage bandwidth of 370 till 400V.
7. After connecting, check the right running direction!
8. Make sure that a possible extension cord is in good condition and suitable for the
transmission of power. An undersized cord reduces the transmission of power and heats up.
9. A damaged cable must be replaced immediately
Operation is only allowed with safety switch against stray
current (RCD max. stray current of 30mA)
Use only permitted extension cable with cross-section the
Voltage
220 V-240 V
50 Hz
Plug 400V:
12.3

Assembly

The machine is pre-assembled. It is only necessary to mount the planer fence, the blade cover
(see exploded drawings) and the mortising unit (optional) on the machine.
HOLZMANN MASCHINEN GmbH
N O T I C E
N O T I C E
one in the following table declared.
5-wire:
with
N-conductor
www.holzmann-maschinen.at
Extension
<27 m
<44 m
<70 m
<105 m
ASSEMBLY

Cross-section

1,5 mm 2
2,5 mm
2
4,0 mm 2
6,0 mm 2
4-wire:
without
N-conductor
HOB 410PRO
29