13.4
Planing
Adjust the cutting depth with the set screw (A).
Adjust the blade cover (C) to let a space of 5mm to the
workpiece.
To start the machine push start button (I).
Press the workpiece with one hand against the planer
table.
Slide the workpiece with the other hand evenly over the
blade shaft.
Push stop button to switch off the machine after work.
Before further activities wait until blade shaft is at a
standstill!
13.4.1
Planing of narrow workpieces
Set the blade cover (C) to a position that the blade shaft
will be covered.
Adjust the blade cover (C) to let a space of 5mm to the
workpiece.
Lay the workpiece with the narrow side to the planer
table and press it with one hand to the angle stop.
Slide the workpiece with the other hand evenly over the
blade shaft.
13.4.2
Planing with tilted angle stop
Set the blade cover to a position that the blade shaft will
be covered.
Adjust the blade cover to let a space of 5mm to the
workpiece.
Lay the workpiece to the planer table and press it with
one hand to the angle stop.
Slide the workpiece with the other hand evenly over the
blade shaft.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
OPERATION
A
32
HOB 410PRO