Safety Devices; Remaining Risk Factors; Assembly; Preparatory Activities - Holzmann HOB 410PRO Betriebsanleitung

11.3

Safety devices

 Blade shaft guard:
Covers the blade shaft when planing, to avoid contact.
 EMERGENCY STOP switch
Stops power unit and feed.
 Safety shutdown
When planning, the machine can not be started, if planer tables and dust collector plug are
not in the required position.
An end switch disconnects the power unit from power supply, when the planer table is
tilted.
When thicknessing, the machine can not be started, if the dust collector plug is not in the
required position.
 Dust collector plug
Covers the blade shaft during thicknessing.
Covers the blade shaft from below during planing.
11.4

Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
 Risk of injury to the hands / fingers by the rotating planer shaft during operation.
 Risk of injury due to sharp edges of the workpiece.
 Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety
regulations must be observed with regard to clothing.
 Risk of injury due to contact with live electrical components.
 Risk of injury by tipping the machine.
 Risk of injury due to dust emissions, treated with harmful agents workpieces
 Risk of injury to the eye by flying debris, even with safety goggles.
 Risk of injury by kickback:
Kickback is a sudden reaction in case of improper handling of the workpiece. This
causes the ejection of the workpiece to the rear direction of the operator.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
12

ASSEMBLY

12.1

Preparatory activities

12.1.1

Delivery content

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
ASSEMBLY
27
HOB 410PRO