Thicknessing Of Workpieces - Holzmann HOB 410PRO Betriebsanleitung

13.5.2

Thicknessing of workpieces

 Unlock the table lever (B) and set the required height of the
thicknessing table with the hand wheel (A).
 The height will be shown on the scale (C).
 Set the thicknessing table height to the workpiece height
minus the requested cutting depth.
 Maximum cutting depth: 5 mm!
 Fix the thicknessing table height with the lever (B).
 To start the feed, set the feeding lever (D) to the upper
position.
 To start the machine, push the start button (I).
 Insert workpiece so that the surface to be machined
facing upwards and push forward.
 The workpiece is pulled through of the automatic feed.
 As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and
take on the finished workpiece.
Long workpieces must be supported.
Property damage and injury by bouncing up the workpiece or tilting of
the machine possible!




HOLZMANN MASCHINEN GmbH
If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
After operation, switch off the machine with the stop button and set the
feed lever to the lower position.
Before further activities wait until blade shaft is at a standstill!
In order for planing, the before described thicknessing procedure must be
reversed.
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
C
D
A
B
HOB 410PRO
35