Planing Of Short Workpieces; Planing Of Workpieces With Small Cross-Section - Holzmann HOB 410PRO Betriebsanleitung

13.4.3

Planing of short workpieces

 At planing short workpieces a push stick has to be used!
 Adjust the angle stop and blade cover to the size of the
push stick.
 Slide the workpiece with the push stick evenly over the
blade shaft.
13.4.4

Planing of workpieces with small cross-section

 When planing workpieces with small cross-section, it is
necessary to mount a wooden assistant stop!
 Mount the wooden assistant stop with clamps like shown
on the right picture.
 Lay the workpiece to the planer table and press it with
one hand to the wooden assistant stop.
 Slide the workpiece with the other hand evenly over the
blade shaft.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
33
HOB 410PRO