Installation; Mounting The Sensor; Retrofit Kit - Mettler Toledo InPro 6000 Bedienungsanleitung

InPro 6000 Series Optical O
4

Installation

The "Plug & Measure"-concept allows the user to mea-
sure oxygen values immediately after installation.
– The sensor is recognized automatically and all rel-
evant data are sent to the transmitter, the oxygen
values are displayed.
The sensor is factory calibrated. The factory calibra-
tion data are stored in the sensor and do not need
to be entered by the user.
4.1

Mounting the sensor

Important! Remove the protection cap before mount -
ing the sensor.
Mounting the sensor in a housing
Please refer to the instruction manual of your housing
explaining on how to mount the sensor in place.
Mounting the sensor directly on a pipe or a vessel
The 12 mm sensors can be mounted directly through
a socket with inside thread Pg 13.5 and securely tight-
ened via the Pg 13.5 threaded sleeve. The sensor can
be mounted in any orientation.
Attention! Do not turn the sensor counter clockwise
when installed in a housing. The cap sleeve might be
loosened.

4.1.1 Retrofit kit

For protection of the sensor head against environmen-
tal influences (temperature, humidity) the use of the
retrofit kit (52 403 811) is recommended. For instal-
lation, see the manual of the retrofit kit.
Retrofit kit
© 07 / 12 Mettler-Toledo AG
Printed in Switzerland
Sensors 12 mm
2
InPro 6000 optical O
11
sensors
2
52 206 256