Putting On An Taking Off The Helmet; Putting On The Helmet 84 K; Taking Off The Helmet; Before Every Journey - SCHUBERTH S1 PRO Gebrauchsanweisung

E. PUTTING ON AND TAKING OFF THE HELMET
1. PUTTING ON THE HELMET
Note:
See section D.8. for operation of the chinstrap / fastener system.
1. Open the chinstrap. Make sure the sun visor is retracted into the
helmet shell.
2. Take the lower ends of the chinstrap and pull these apart.
3. It will now be easy to put the helmet on.
4. To fasten the chinstrap, thread its free end through the double
D-ring fastener, pull tight and fasten(for operation of the double
D-ring fastener, please refer to Chapter D.8., Retention system).
5. Make sure the chinstrap passes under the chin and fi ts fi rmly.
Note:
Check regularly that the chinstrap is correctly positioned and
adjusted to the correct length (see Section F.2.).
2. TAKING THE HELMET OFF
1. To open the chinstrap, pull the red lug of the double D-ring fastener
and withdraw the chinstrap through the metal eyes.
2. Grasp the ends of the chinstrap and pull the chinstrap ends apart.
3. The helmet can now be removed easily from the head.
Tip:
To avoid scratching any objects you might place the helmet on,
we recommend closing the chinstrap again after you have taken
the helmet off.
84
F. BEFORE EVERY JOURNEY
For your safety, check the following points before every journey:

1. CHECKING THE HELMET

Check the helmet regularly for damage. Small superfi cial scratches will
not impair the protective function of your helmet. In the case of more
serious damage (cracks, dents, fl aking and cracking paint, etc.), the
helmet should no longer be used.
Note:
If your body weight has dropped signifi cantly, you should check
that your helmet is still the right size for you (see Section C.3.).
2. CHECKING THE CHINSTRAP (with helmet on and fastened)
1. Check that the chinstrap passes under your chin.
2. Slip your index fi nger under the chinstrap and pull.
- If the chinstrap is loose under the chin, it is adjusted too long
and needs to be tightened.
- If pulling with your index fi nger loosens the chinstrap, it's not
properly fastened! Completely undo the chinstrap and try
fastening it again. Repeat the test.
3. If you are unable to fasten the chinstrap so that it is fi rmly against
the chin, check that your helmet is still the right size for you (see
Section C.3.).
85