NSK VarioSurg3 Betriebsanleitung Seite 8

4-1-2 LCD Display on the Operation Panel
(E) POWER
Bar Graph
(F) Brightness (G) Coolant Flow Level
(A) Surgic Pro Display
This is displayed only when the this VarioSurg 3 is connected to NSK Surgic Pro via the NSK Link Set and
Surgic Pro has been selected by SELECT key.
*For the Link function, refer to "8-3 Link function with Surgic Pro".
(B) POWER Display
Displays when vibration is active from the Handpiece.
(C) POWER Level Display
Displays the set Power Level (5 – 150%).
(D) Program Number
Displays the selected program number.
(E) POWER Bar Graph
The relevant POWER level is indicated by the number of indicator bars illuminated.
Each lower horizontal bar represents 50 %.
Each upper vertical bar represents 10%. The maximum number of bars is 15.
In Auto Cleaning mode, the countdown of the remaining time is displayed.
(F) Brightness
Displays the selected illumination intensity.
(G) Coolant Flow Level
The selected Coolant Flow is displayed on a scale of 1 - 5 (1 is the least flow).
(H) Mode
Displays the selected Mode.
(I) Burst Output Level
Displays the Burst Output setting. Displays only in SURG Mode.
NOTICE When the transparent protective sheet on the Operation Panel is peeled off or when an object charged
with static electricity is placed near the LCD Display, fine lines may appear in the display area. This is
normal and the lines will disappear after a short time.
(A) Surgic Pro Display (B) POWER Display (C) POWER Level Display
(H) Mode
7
(D) Program
Number
(I) Burst Output Level