NSK VarioSurg3 Betriebsanleitung Seite 7

(6) BURST key
To set the Burst Output Level (only for the SURG Mode)
Each time the key is pressed, the setting changes as follows: OFF B1 B2 B3 OFF.
*Burst function: Increases and decreases vibration at regular intervals. Select an appropriate setting according
to the hardness of the patients' bones (bone density).
*Frequencies for Burst are B1: 10Hz, B2: 30Hz and B3: 60Hz.
(7) SELECT key
This key is used when two systems (NSK VarioSurg 3 and NSK Surgic Pro) are operated by a single Foot
Control.
*Surgic Pro (sold separately) and the Link Set (sold separately) are required in order to use this key.
(8) AUTO CLEANING key
For cleaning the irrigation circuit in the Handpiece and tube.
(9) MEMORY key
To set the program memory for the values which are displayed in the Panel.
(10) PROGRAM key (- +)
For calling up the set values memorized in the program.
(11) POWER key (- +)
For setting the Power Level.
By pressing (+) and (-) keys, the set value increases and decreases respectively.
*When the key is held down, the value increases or decreases continuously. However, when (+) key is held
down, the value stops at 100% for the sake of safety. If you want to further increase the value, press the key
again.
NOTICE Program numbers are allocated to each Mode as shown in the following table. Each program number can
be set only for the allocated Mode.
Program No. Mode
1
2
3 SURG
4
5
6
ENDO
7
8
PERIO
9
*1 Burst function: Vibration levels can be changed at certain intervals. Levels can be selected depending on patient's
bone hardness (density).
*2 The amount of water flow may vary slightly depending on the condition of the Irrigation Tube.
While the Handpiece is vibrating, the following keys cannot be operated.
(3) P key
(5) S key
(8) AUTO CLEANING key
(10) PROGRAM key (- +)
1
Burst function*
Available
(Off, B1: 10Hz, 10 – 150%
B2: 30Hz, In multiples of 10%
B3: 60Hz)
5 – 100%
Not available Below 50%, multiples of 5%.
50% and larger, multiples of 10%.
(4) E key
(7) SELECT key
(9) MEMORY key
Power range
17 - 95 ml/min*
3 - 55 ml/min*
6
Coolant flow
Lighting brightness
(5 levels)
2
OFF/LOW/HIGH
2