General Cleaning - Carl Valentin SPECTRA II Kurzanleitung

Cleaning
DANGER!
Risk of death by electric shock!

Disconnect the label printer from power supply before performing any maintenance work.
NOTICE!
When cleaning the label printer, personal protective equipment such as safety goggles and gloves are
recommended.
Cleaning task

General cleaning.

Cleaning print roller.
Cleaning printhead.
Clean label photocell.
NOTICE!
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure
good ventilation.
WARNING!
Risk of fire by easily inflammable label soluble!

When using label soluble, dust must be completely removed from the label printer and cleaned.
General cleaning
CAUTION!
Abrasive cleaning agents can damage the label printer!

Do not use abrasives or solvents to clean the outer surface of the label printer.

Remove dust and paper fuzz in the printing area with a soft brush or vacuum cleaner.

Clean outer surfaces with an all-purpose cleaner.
Frequency
As necessary.
Each time the label roll is changed or when the printout and
label transport are adversely affected.
Direct thermal printing:
Each time the label roll is changed.
Thermal transfer printing:
Each time the transfer ribbon is changed or when the printout
is adversely affected.
When the label roll is changed.
English
Spectra II
67