Kärcher KM 100/100 RG Handbuch Seite 26

 Open the fastening screws of the side
panels on both sides.
 Remove side panels.
 Front sealing strip
 Slightly loosen retaining nuts for the
front sealing strip; to replace, unscrew.
 Screw on new sealing strip without fully
tightening the nuts.
 Adjust sealing strip.
 Set the distance of the sealing strip to
the floor so that the bottom edge trails
behind at a distance of between 35 and
40 mm.
 Tighten nuts.
 Rear sealing strip
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
 If worn, replace.
 Remove roller brush.
26
 Unscrew retaining nuts for rear sealing
strip.
 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.
 Tighten nuts.
 Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Turn main key to "0" and remove it.
 Open the hood, insert retaining rod.
1 Filter holder handle
2 Locking
3 Axle
 Pull the lock upwards.
 Pull out the axle on the handle of the fil-
ter holder until the lock engages (nut in
axle).
 Remove the lamella filter.
 Insert new filter.
10
-
EN
 Make sure driver engages with holes on
drive side.
 Push the axle inwards again so it locks
into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing filter case seal
 Lift filter case seal out of groove in the
cover.
 Insert new seal.
Checking drive belt
 Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
Check cup seal
 Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing fuses
 Loosen screws on both sides of the
panel.