Mittelmann UniDrive Originalbetriebsanleitung / Prüfbuch Seite 72

Original Operating Instructions UNIDRIVE
Powerlink (cordless screwdriver fixing on the UNIDRIVE)
•
For use as a working device, the above listed products are so combined for a planned work assign-
ment that secure, comfortable working is enabled.
The MKA20 E Klick Fit is recommended as a full body harness. With this combination the body of the
user is so held and supported that comfortable working is made possible. The SP2 seat cushion with
footrest provides relief to the body in the full body harness.
Application Travelling:
The UNIDRIVE working device is fastened to the front eyelet of the full body harness and to the seat
cushion eyelet. Thereby is ensured that the user is attached in a sitting position.
The free fastener (top) of the UNIDRIVE is attached to a suitable anchor point.
As an additional second safeguard for the user, the safety rope is attached to a second anchor point
and the fasteners of the guided-type fall arrester are attached to the rear eyelet of the body harness.
With this protective arresting device, the user is permanently protected against falling. In the event of a
fall or a too high a descent speed, the guided-type fall arrester is arrested and brings the user to a
safe stop.
Information
:
Initial instruction and training by the manufacturer, or an instructor trained by him, before commission-
ing is required by law as only a trained user is safely in control of the UNIDRIVE equipment in all work
situations.
14.1 Technical Data and Marking of the Working Device
Manufacturer:
Product:
Type:
Descent rope:
Mittelmann Sicherheitstechnik GmbH & Co. KG
Descender / Rescue Lifting Device
UNIDRIVE
Mittelmann sheathed core rope Ø 10.5 mm -
EN 1891:1998
Weight: 71.5 g/m (Ø 10.5 mm)
Elongation 3% (Ø 10.5 mm)
Material: polyamide
Page 28