Associated Documentation - Mittelmann UniDrive Originalbetriebsanleitung / Prüfbuch

Original Operating Instructions UNIDRIVE
Heavy soiling and wear of the lifting gear can adversely affect the functioning of the equipment.
Therefore, for reasons of safety, the lifting gear must be replaced as and when required or at the
latest after 4 years. Exclusively, only lifting gear specified by the manufacturer must be used. Re-
placements must only be carried out by the manufacturer or by persons authorized by him in writ-
ing.
The manufacturer accepts no liability whatsoever for damage or injury resulting from incorrect and
/ or improper service and / or repair work carried out by third parties.
Corrosion resistance when used in the open air is to a large extent ensured not only by the selec-
tion of the appropriate materials but also by protective surface coatings, whereby this must be
supported by the appropriate regular maintenance.
Emissions emitted by this machine are sound pressure values only which lie below 75 dB(A).
Appropriate special precautions must be taken for the transport and storage of the UNIDRIVE. For
this a suitable transport and storage box should be used. In every case here, the operating in-
structions of the additional personal protective equipment against falling must be complied with.
6. Important Information
6.1 Testing and Approval of the Device
The UNIDRIVE is a type-tested Category III personal protective equipment product against falls. Pro-
duction of the equipment is subject to monitoring by the accredited certification body, DEKRA EXAM
GmbH with the identification number 0158, Dinnendahlstr. 9, 44809 Bochum.
The UNIDRIVE has been tested and approved as a system. Every change to the system is life-
threatening and leads to the loss of the approval and the loss of the liability of the manufacturer.
6.2

Associated Documentation

Supplementary to these original operating instructions, all individual operating instructions – especially
warning information – of the components which are used together with the UNIDRIVE must be read
and understood before commissioning.
Page 15