Changing The 2 A Input Fuse - Wetekom EM-3201A Bedienungsanleitung

Changing the 2 A Input Fuse (7)

Procedure:
• Turn off the unit and disconnect all measuring cables
from the sockets and terminals of the unit.
• Loosen the screws on the back of the unit marked with
the white rings in the picture (see "Replacing the
Battery"). Lift off the rear cover.
• Now remove the battery.
• Now loosen the screws marked in the picture with the
white rings.
• After that, flip forward the circuit board and find the fuse
marked in the lower picture with a white ring.
• Carefully remove it and replace it with a fuse of the
same type and dimensions (F2A/250V Ø5x20mm).
• After the fuse has been replaced, assemble the unit in
reverse order.
CAUTION! Never Operate the Unit with the Housing
Open.
Cleaning and Maintenance
33