Technical Specifications; Putting The Machine Into Service - Grillo G52 Bedienungsanleitung

ENGINES
ROBIN SUBARU EX17, 169 cc, 5 HP @ 3600 r.p.m., one-cylinder petrol engine
KOHLER 3000, 196 cc, 5,5 HP @ 3600 r.p.m., one-cylinder petrol engine
MACHINE
Recoil starter
Fuel tank capacity: 3,7 lt. (EX17 – KOHLER 3000)
Gearbox: oil-bath gears, one forward gear and one reverse gear.
P.T.O.: 644 r.p.m. anticlockwise in walking tractor version – 965 r.p.m. clockwise in sickle-bar
version.
Implement quick coupling: 50 mm Ø
Safety devices: active coupling (by releasing the levers on the handlebar, both the wheels and the
implement will stop immediately)
Rotary tiller: 500 mm standard and adjustable at 370 mm.
Tilling depth: 130 mm.
Handlebar: side and height adjustable, reversible and mounted on shock-absorbers.
Forward (walking tractor)
Reverse (walking tractor)
Forward (sickle-bar)
Reverse (sickle-bar)
Track: external measurements with tyres 13×5.00-6 > 400 mm
Attachments: 86 cm mulching cutting bar, 96 cm double cutting bar, 50 cm rotary cutter, 80 cm
pivoting front blade, furrower behind the tiller, 50 and 85 mm wheel extensions, snow chains, 80
cm pivoting and tilting sweeper.
1) Check that the machine has not been damaged during transport.
2) Remove the walking tractor from its packaging paying attention not to damage levers and
cables. Use a lifting machine (capacity: 200 kg).
3) The walking tractor is delivered with the handlebar bent over the engine (sickle-bar version). If
the handlebar is to be used with the rotary tiller push the lever (fig. 9) and slowly turn the handlebar
180°, paying attention not to damage the cables.
4) Before connecting the attachment grease both the PTO and the 3-teeth coupling, then mount
the attachment (e.g. rotary tiller, cutting bar) by completely inserting the attachment into the
coupling of the walking tractor (fig. 4). To fix the attachment turn the lever of the quick coupling into
position "BLOCCATO" (LOCKED – fig. 5, A).
5) Add engine oil (please refer to the appropriate manual).
6) Check oil in the gearbox (fig. 6). If necessary add 80W90 oil, quantity 750 gr.
7) Add oil into the oil-bath air filter (for versions provided with this type of filter), use the same oil
type as the engine oil (fig. 6, n. 4).
8) Verify the tyre pressure according to the table provided.
13x5.00-6
9) Fill the tank with fuel using a funnel provided with a fine filter.
10) Check the various liquid level with the machine in horizontal position.
Translation of the Original Instructions
TECHNICAL SPECIFICATIONS G52
Gears

PUTTING THE MACHINE INTO SERVICE

TYRE PRESSURE
2 PLY RATING
Speeds with tyres 13×5.00-6 (km/h)
8
1,4
2,2
2,2
1,4
2,2 BAR