Tail Light; Turn Indicators; Replacing The Headlight Bulbs - Beta Motorcycles RR 50 CC ENDURO Bedienungsanleitung

4
REPLACING THE HEADLIGHT
BULBS
2
Remove the fixing screws and move for-
ward the lamp holder front cowl.
Carefully remove the headlight bulb 1
together with lamp holder. To replace
the high beam/low beam, lift the rubber
cover 2, release connector, push on the
spring 3 and remove the lamp holder and
1
replace the light bulb with a new one. Be
careful not to touch the bulb so as not to
3
compromise its efficiency.
To refit, follow the procedure above but in
reverse order.
Fasten the lamp holder front cowl to the
supporting pins and fix it with the two
elastics.

TAIL LIGHT

Keep the tail light glass clean at all times
(see page 54).
The LED tail light is sealed. In the case of
burnout of one or more LEDs it is necessary
to replace the entire group.
To replace, contact authorised Betamotor
customer service.

TURN INDICATORS

To reach the bulb, remove the glass cover
by loosening screw 1.
Remove the bulb from the lamp holder
and replace.
1
EN
53