Connecting And Re-Launching The Audio Signal And Rdnet - dB Technologies VIO-L210 Bedienungsanleitung

CONNECTING AND RE-LAUNCHING THE AUDIO SIGNAL AND RDNET

The illustration above shows a generic connection, in which module 1 is above module 2, this time
showing audio and network connections. For this purpose, use non-provided cables, with XLR (audio)
and etherCON/RJ45 (network) connectors. For further information on the types of cables available,
see also the image on the next page.
• For the audio connection, connect the cable originating from MIXER/LINE to the BALANCED
AUDIO INPUT (A) of module 1 of the line array. Re-launch the signal between the first and
the second module. For this purpose, connect the output BALANCED AUDIO OUTPUT/LINK (B)
of module 1 to the BALANCED AUDIO INPUT (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules
of the line array are connected.
• For the network connection, connect the DATA IN (A) connector of module B to the remote
control (RDNet CONTROL 2 or RDNet CONTROL 8). Re-launch the signal by connecting DATA
OUT (B) of module 1 to DATA IN (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules
of the line array are connected.
WARNING
• Replace any damaged cables to prevent malfunctions and poor sound quality.
VIO-L210
50
A
MODULE 1
B
MODULE 2
C
!
English
A
B
C
Cod. 420120248 REV. 1.1