Acoustic Prediction / Mechanical Testing; Configuration; Preparation Of The Fly-Bar And Modules - dB Technologies VIO-L212 Bedienungsanleitung

English

ACOUSTIC PREDICTION / MECHANICAL TESTING

• Use DBTECHNOLOGIES COMPOSER to set project parameters.
• Make sure that the MECHANICAL SAFETY testing of the software confirms the safety of the selected

configuration

• Make sure that the local parameters of the different modules are correctly set on the single amplifier panels.
In particular, verify according to the project the Speaker Coupling and High Frequency Compensation settings.
As an alternative, all parameters can be remotely edited in real time if the line-array connection is carried out
through the RDNet network (DBTECHNOLOGIES NETWORK). Nevertheless, in this case, project initial settings
should be physically repeated on the VIO-L210 modules before installation. For further information see the
DSP PRESET PARAMETERS AND REMOTE CONTROL

PREPARATION OF THE FLY-BAR AND MODULES

• Prepare the DRK212 fly-bars and the line-array VIO-L212 modules. This example shows dollies DT-DRK212
and DT-VIOL212 with DTT-VIOL212 tops. The configuration in the example, for illustrative purposes only, is an
8-module line-array.
THE CONNECTIONS
SUGGESTED IN
THE FOLLOWING
PICTURES ARE FOR
INFORMATION
ONLY.
VIO-L212
section.
Code 420120270 REV. 1.0
45