Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
The assembly of the 2 modules A and B requires a few easy steps:
•
On module A, remove the pins [3], raise the retractable brackets [2] and fasten them to the new position
using the pins [3].
•
Remove the pins [1] from module B, place it on top of module A, inserting the brackets [2] as shown. Then
fasten the front side of the two modules using the pins [1] of module B.
•
On the back, remove the pins [5] from the rear brackets [4]. Then insert the movable arm [6] of module
B into the bracket [4] of module A. The next page shows in detail the fastening of the angle on the rear
between the two modules.
VIO-L210
Cod. 420120248 REV. 1.1
37
Werbung
Kapitel
Inhaltsverzeichnis
