dB Technologies VIO-L210 Bedienungsanleitung Seite 53

English
• Fix the brakes on the DT-VIOL210 wheels.
• On the back, insert the movable arms [6] into the brackets [4] as shown in the
• Insert the pins corresponding to the previously calculated angles inside the arms (for this operation,
you do not need to lift the modules).
• Perform audio, RDNet and power supply re-launch connections as described in the previous paragraphs.
To find the maximum number of power connections in a re-launched system, see the
SPECIFICATIONS section.
• Remove the top cover and the tubes on the back of DT-VIOL210.
• Mount the DRK-210 fly-bar on the top module according to the settings verified with the
DBTECHNOLOGIES COMPOSER.
• Lift the 4 modules anchored to DRK-210 using one or two engines and the appropriate means for
rigging (not provided).
• Remove the brakes from the DT-VIOL210 wheels and put the dolly back in the rest position.
WARNING
DRK-210 was designed for the suspension of up to 25 VIO
L210 (or 16 Sub modules) for a maximum of 1653 lbs (750 kg)
with a single coupling point.
The VIO L210 suspension components allow you to
connect up to 10 modules (661 lbs (300 kg) max) without
limiting the angulation of the line array. Any other
configuration or information regarding the system's data,
such as the maximum capacity and attachment points, must
be verified prior to the installation using the dBTechnologies
Composer software (see the relevant paragraph in this
user manual). It is available for free on the website
www.dbtechnologies.com under the DOWNLOADS section.
VIO-L210
!
MECHANICS paragraph.
TECHNICAL
Cod. 420120248 REV. 1.1
53