dB Technologies VIO-L210 Bedienungsanleitung Seite 38

The example shows the case in which you want to set a 3° angle between the 2 modules.
Before carrying out any other operation, make sure that once the movable arm is inserted [6], the hole of the
chosen angle is contained inside the loop as shown.
• FLOWN CASE: insert only one pin in the hole on the chosen angle. The second pin can be housed in the
"PIN HOLDER" hole. Note that this type of configuration during the assembly allows changing the chosen
angle simply by moving the respective pin (with the movable arm inserted).
• STACKED CASE: once the pin [5] is inserted into the hole of the chosen angle, lift module B as far as the
movable arm [6] allows. At this point, insert the second pin into the "ANGLE LOCK" position and release
module B. This way, module B is completely blocked by the two pins on the rear.
After assembly is completed, always make sure that all the pins have been completely inserted and are well
locked.
VIO-L210
38
English
Cod. 420120248 REV. 1.1