English
4. CONNECTIONS
CONNECTING AND RE-LAUNCHING THE POWER SUPPLY
The illustration above shows a generic connection, in which module 1
is under module 2. For this purpose, use cables with powerCON TRUE1® connectors (not provided).
•
Connect the power supply of module 1 AUTO-RANGE MAINS INPUT (A).
•
Re-launch the power supply from module 1 to module 2 by connecting the MAINS LINK output (B)
of module 1 to the AUTO-RANGE MAINS INPUT (C) of module 2.
•
Repeat this operation until you have connected the maximum permitted number of line array
modules (see the chapter
WARNING
•
VIO-L210
TECHNICAL
SPECIFICATIONS).
!
The cables must be properly sized and the system's design, installation and
testing should be performed by qualified personnel only. AEB industriale declines
any responsibility in case of cables that are non-compliant, uncertified and
incompatible with the proper layout of the system and the regulations in force
for the country of use.
A
MODULE 1
B
C
MODULE 2
Cod. 420120248 REV. 1.1
49