Connecting And Linking The Rdnet Signal; Remote Control - dB Technologies VIO X 310 Bedienungsanleitung

CONNECTING AND LINKING THE RDNET SIGNAL

To enable remote control, connect the Data Input of the first speaker to the hardware interface (RDNet Control
2 or RDNet Control 8) using cables fitted with etherCON connectors. Then connect the Data Output of the first
speaker to the Data Input of the second, and so on. Power up the speakers and make a "GoOnline" request in the
AURORA NET software; the "Link" LEDs will confirm that they are connected.
The "Active" LEDs will start flashing to indicate that there is data traffic.
RDNET
CONTROL

3. REMOTE CONTROL

The AURORA NET software lets you manage several parameters of the VIO X310 speaker in real time.
In detail:
• Monitor the input and output signals
• View if there is audio compression on the output signal and acoustic components
• Attenuate the input signal
• MUTE the driver, midrange and woofer separately
• SOLO the driver, midrange and woofer separately
• Monitor the temperature of the amplifier
• Select the high pass filter cut-off frequency
• Save settings as presets for subsequent remote recall
• Equalise the speaker
• Add delay
VIO X310
30
English
Cod. 420120424 REV. 1.0