Connecting Outputs Between Multiple Modules (Audio Signal Linking) - dB Technologies INGENIA IG1T Bedienungsanleitung

The use of Neutrik® PowerCON TRUE1® connectors on IG1T allows to link the power supply of the first speaker
with a subsequent one, up to a maximum current of 15 A (3400 W) for the countries where voltage is 220-240Vac,
and of 14 A (1600 W), for the countries where voltage is 100-120Vac. To make this type of connection, simply
plug the power cord supplied to the MAINS INPUT (8) of the first IG1T and connect the cable LINK powerCON
TRUE1® (optional) between the MAIN LINK output (9) and the MAINS INPUT (8) of the next IG1T. It is possible to
repeat this type of connection until it is achieved the maximum allowed current as indicated by the MAINS LINK
connector (9) of the first speaker.
CAUTION!
The maximum allowed current indicated on the rating plate of IG1T (MAIN LINK) is calculated from the
specification of the maximum current of the PowerCON TRUE1
but depends on the type of cable used for the connection to the power grid of the first IG1T (section
and type of plug used) and on the subsequent LINK cables (section and type of cable). Always check
during the design and sizing stage of the system and before making any connections in series among
the products, the maximum allowable currents (and powers) and the exact sizing of the sections of the
cables used.

CONNECTING OUTPUTS BETWEEN MULTIPLE MODULES (audio signal linking)

AUDIO INPUT
To connect 2 or more speakers to the same audio source, it may be useful, in some installation configurations,
to link the signal from the first one to a second one and so on. First of all connect a sound source of any type to
the "INPUT" input (6) of the first speaker (for the "LINE" or "MIC" connection, which is different, please refer to
section CONNECTING THE
speaker to the "INPUT" input (6) of the second one. This second operation can then be repeated to connect other
speakers, to get the installation layout that is the most appropriate for the context.
INGENIA IG1T
50
All manuals and user guides at all-guides.com
LINK
INPUTS). Using a balanced XLR cable, then, connect the "LINK" output (5) of the first
®
connector; this value is not absolute
Cod. 420120237 REV. 1.1
English