Hydraulic System - Ammann ARW 65 1B40 Originalbetriebsanleitung

6.6.7 Exciter
B6599027.cdr
The exciter is largely maintenance-free. An oil-change should
only be carried out if the exciter has been repaired.
Check the oil level periodically by opening the inspection screw
(1). If necessary, top up to the upper edge of the inspection hole.
1

6.7 Hydraulic system

Before working on the hydraulic make the system
pressureless.
Carry out the change of hydraulic oil while it is still
Attention
warm in accordance to the lubrication plan and
the lubrication table.
Do not start the motor while the hydraulic oil is
draining under any circumstance.
Immediately replace any damaged seals.
Change the return filter element and the air filter
with each change of hydraulic oil.
Change the hydraulic oil also after each major re-
pair on the hydraulic unit.
Collect the drained-off hydraulic oil and dispose it
in an environment friendly manner.
Environment
6.7.1 Hydraulic hose lines
B8299325.cdr
1 Ammann Article No.
2 Manufacturer/Month and year of manufacture
3 Max. operating pressure
The function of hydraulic hose lines must be tested at regular in-
tervals (minimum once a year) by an expert (with a knowledge of
hydraulics).
Hose lines must immediately be replaced in the following in-
stances:
• Damage to the outer layer to the inner lining (abrasion marks,
cracks, cuts, etc.).
• Brittleness of the outer layer (cracking of hose covering).
• Unnatural deformations of the hose line. This applies to both a
pressureless and pressurised condition (e.g. layer separation,
blister formation, crushed areas, kinks).
• Leaks.
• Damage or deformation of hose fittings (impaired sealing
function).
• Hose slips out of the fitting.
• Corrosion of fitting (degrading of function and strength).
• Improper installation.
• Use beyond the expiry date of max. 6 years.
46
6. Maintenance
1
2
3