Safety; Safety And Responsibility - SOMFY J4 RTS Installationsanleitung

CONTENTS
2. Safety
2.1. Safety and responsibility
2.2. Specific safety advice
3. Installation
3.1. 57 x 51 mm or 58 x 56 mm head rail,
open below
3.2. 58 x 56 mm head rail, open above
3.3. 57 x 51 mm head rail, open above
3.4. 78 X 67 mm head rail, open below
3.5. 67 X 66 mm head rail, open below
4. Wiring
5. Commissioning
5.1. Identifying setting steps already
completed
5.2. Pre-programming the Somfy local
control point
5.3. Checking the motor's direction of
rotation
5.4. Selecting the type of E.V.b. (type 1 or type
3)
5.5. Setting the end limits
5.6. Programming the first Somfy local
control point
5.7. Checking the settings

1. SAFETY

1.1. Safety and responsibility

- The motor, torque and operating time must be adjusted according to the complete installation.
- Only Somfy original accessories should be used (adapters, brackets, connectors, power cable, etc.).
- Correct operation of the installation is only guaranteed if the installation and assembly have been
carried out according to best practices, if the electrical supply is adequate and if maintenance is carried
out.
© 2013-2016 Somfy SAS. All rights reserved.
67 6. Operation
67 6.1. Standard operation
68 6.2. Operating with a Somfy sensor
70 7. Additional settings
7.1. Favourite position (my)
70
7.2. Adding/Deleting Somfy control points
70
and sensors
71
7.3. "Sun disappearing" position»
72
7.4. Modifying the slat tilt angle in relation
73
to the notches on the thumbwheel
7.5. Modifying the thumbwheel's direction
74
of rotation
75
7.6. Modifying the motor's direction of
rotation
75
7.7. Modifying the end limits
75
8. Tips and recommendations
8.1. Questions on the J4 RTS?
76
8.2. Replacing a lost or broken Somfy
control point
76
8.3. Restoring the original configuration
76
9. Technical data
78
78
78
78
79
80
80
81
82
83
83
83
84
85
85
85
86
86
67