Tips And Recommendations; Questions On The J4 Rts; Control Point - SOMFY J4 RTS Installationsanleitung

7. TIPS AND RECOMMENDATIONS

7.1. Questions on the J4 RTS?

Observations
The E.V.B. does
The wiring is incorrect.
not operate.
The motor is in heat protection mode. Wait until the motor cools down.
An incorrect cable has been used.
The Somfy control battery is weak.
The control point is not compatible.
The Somfy control point used has not
been programmed into the motor.
The E.V.B. stops
The end limits have been incorrectly
too early.
set.
I can't tilt the slats
The remote control is not compatible Pair then use a Telis Mod/VAR RTS remote
easily
7.2. Replacing a lost or broken Somfy control point
This reset deletes all control points, however,
it does not delete the sensors and the favourite
position.
Only switch off the power for the motor to be reset.
Do not place the blind, in the Upper end limit !
• Cut the power supply for 2 seconds.
• Next:
Switch the power supply back on for 5 to 15
seconds.
A
Cut the power supply for 2 seconds.
Switch the power supply back on: the E.V.B.
starts to move for a few seconds.
• or
Switch the mains power supply back on.
B
Wait for 5s then press·and·hold·the·»mushroo
m»·for·10·seconds.
the E.V.B. moves briefly.
If the E.V.B. is at the lower end limit, it will move
briefly.
• Press the PROG button on the new control point
until the E.V.B. moves briefly: all RTS control
points are deleted and the new RTS control point
is programmed into the motor.
© 2013-2016 Somfy SAS. All rights reserved.
Possible causes Solutions
Check the wiring and modify it if
necessary.
Check the cable and ensure it has 3
strands.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or
program this control point.
Readjust the end limits.
control
A
5 sec.
ON
OFF
15 sec.
2 sec.
ON
OFF
2 sec.
B
ON
85