Preliminary Checks; Installation Environment; Electrical Installation; Safety Instructions - SOMFY DEXXO PRO RTS Installationsanleitung

Dexxo Pro RTS
change to the standards or to the motorisation.

1.3 Preliminary checks

> Installation environment
ATTENTION
Do not spray water onto the motorisation.
Do not install the motorisation in an explosive environment.
Check that the temperature range marked on the drive is
suited to the installation location.
> Condition of the door to be motorised
- the door is in good mechanical condition
- the door is correctly balanced
-
- the door can be correctly opened and closed manually
>

1.4 Electrical installation

-
-
> Cable feed
Underground cables must be equipped with a protective
and the accessories cables.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
DANGER
WARNING
DANGER
1.5 Safety instructions relating to installation
Do not connect the motorisation to a power source
part are avoided or indicated on the installation (see the
section "Danger zones").
an additional element not recommended in this manual is
strictly prohibited.
until installation is complete.
Do not use adhesive to secure the motorisation.
release device near to its mobile component.
Take care when using the manual back release device as
ATTENTION
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
the motorisation changes direction when the door
> Safety devices
photoelectric cells must be installed.
direction with no intentional activation by the user.
required to comply with the regulations in the country in
which the motorisation is installed.
WARNING
DANGER
WARNING
WARNING
WARNING
WARNING
EN
2