Sun Disappearing" Position - SOMFY J4 RTS Installationsanleitung

6.3. Sun disappearing position (SDP)
6.3.1. Modifying/Activating the "sun disappearing" position
Note: The "sun disappearing" position is the position the slats adopt when the sun is
disappearing. This function requires the use of a sun sensor. The "sun disappearing" position
is preset in the factory but not activated, and corresponds to the "slats horizontal" position. It
is not possible to modify the "sun disappearing" position if the "my" position has been deleted.
• Press the "my" button: the blind starts to move then stops
in the favourite (my) position.
• Press and hold the "my" and Up buttons for 2 seconds: the
E.V.B. is raised to the "sun disappearing" position.
• Position the slats as desired using the thumbwheel (Mod/
Var RTS remote control) or by pressing the Up and Down
buttons on a paired or temporarily assigned Mod/Var RTS
remote control to increase or reduce the slat angle.
6.3.2. Programming the "sun disappearing" position
In the "sun disappearing" position, press and hold the "my"
button on a paired RTS remote control for 5 seconds: the
E.V.B. moves briefly; the "sun disappearing" position has
been programmed.
6.3.3. Deleting the "sun disappearing" position
• Press the "my" button: the blind starts to move then stops
in the favourite (my) position.
• Press and hold the "my" and Up buttons for 2 seconds: the
E.V.B. is raised to the "sun disappearing" position.
• Press and hold the "my" and Up buttons for 5 seconds:
the E.V.B. moves briefly; the "sun disappearing" position
is activated or deleted.
6.3.4. Activating and Deactivating the "privacy position"
the "privacy position" locks the E.V.B. in position if the sun
disappears.
• Press the "my" button: the E.V.B. starts to move then stops
in the favourite (my) position.
• Press and hold the "my" and Down buttons for 5 seconds:
the E.V.B. moves briefly; it will not change position when
the sun disappears.
82
© 2013-2016 Somfy SAS. All rights reserved.
SDP
SDP