Preliminary Checks; Electrical Installation; Safety Instructions Relating To Installation - SOMFY DEXXO PRO io Serie Installationsanleitung

Dexxo Pro io
Any use of this product outside the scope of application
described in this manual is prohibited (see "Scope of
application" paragraph in the installation manual).
The use of any accessories or components not validated
by Somfy is prohibited - safety of persons won't be
ensured.
Somfy cannot be held liable for damages resulting from non
compliance with the instructions of this manual.
somfy.com.
change to the standards or to the motorisation.

1.3 Preliminary checks

> Installation environment
ATTENTION
Do not spray water onto the motorisation.
Do not install the motorisation in an explosive environment.
> Condition of the door to be motorised
- the door is in good mechanical condition
- the door is correctly balanced
- the door can be opened and closed properly using a force
door springs (the door may fall).
- The door mountings are in good condition.
-
Strengthen these if necessary.
>
Make sure the parts of the door do not encroach onto the
pavement or public thoroughfare.
must be equipped with a system that prevents it from
moving when the wicket door is not in the safety position.
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
WARNING
DANGER
WARNING

1.4 Electrical installation

The installation of the power supply must comply with the
standards in force in the country in which the motorisation
The electric line must be exclusively reserved for the
-
-
An all-pole supply cut-off device must be provided.
(maximum residual voltage 2 kV).
> Cable feed
Underground cables must be equipped with a protective
and the accessories cables.
withstand the weight of vehicles (ref. 2400484).

1.5 Safety instructions relating to installation

cords or chains and deactivate any locking device (bolt)
which is not required for motorised operation.
battery or solar) before installation is complete.
elements caused by the opening movement of the driven
part are avoided or indicated on the installation (see the
.
to the end-user.
Modifying one of the elements provided in this kit or using
an additional element not recommended in this manual is
strictly prohibited.
Monitor the door as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the motorisation.
Install the internal manual back release device at a height
of less than 1.8 m.
release device near to its mobile component.
Take care when using the manual back release device as
DANGER
WARNING
DANGER
WARNING
WARNING
WARNING
2