Initial Operation; Unpacking - Storch High-Dry 300 Bedienungsanleitung

CONTROL PANEL AND CONTROL KNOB
1. Control panel
2. Control knob

3. Initial operation

UNPACKING

The High-Dry 300 dehumidifier is delivered individually packaged and the packaging should be removed as follows:
Keep the carton upright, do NOT place the packaging upside down (the labelling on the package must be upright).
Now use a pair of scissors, or other similar object, to cut the bands that secure the base of the package and lift the
packaging upwards. Now remove the top protective layer of polystyrene. Then lift the device from the lower transport
packaging and place it on the floor. Finally, remove the plastic film.
The handle for transporting the device is supplied loosely in the packaging. Please remove the screws located in the
two tubes, position the handle on the handle bracket that is fitted to the device and screw the tubes in place by using
the screws you have just removed.
The control panel (1) is located in the upper cover of the
device and is equipped with four control lights. The con-
trol knob (2) for switching the device on/off and adjusting
the humidity level can be found on the rear of the dehu-
midifier.
A brief description of the function can be found under
each control light.
Green "FULL" light:
If this light switches on, the device shuts down, as it
means the container is full of condensate.
Red "POWER" light:
This indicates that the plug is connected to the electric
circuit and that the device is being supplied with power.
Red "WORKING" light:
This switches on if the moisture meter releases the ope-
ration of the dehumidifier; if the "DEFROST" and "FULL"
lights are switched off, the compressor is operational.
Red "DEFROST" light (Pause):
This indicates that the compressor is ready to switch on;
this occurs during each start-up phase and during the
defrost process, which is conducted cyclically.
The desired level of humidity in the room can be regu-
lated by using the control knob. A higher number incre-
ases the dehumidification level of the air. In other words,
setting '1' will produce a dehumidification level of approx.
95% (always dependent on ambient conditions!), setting
'5' will produce approx. 35% r.h. and the 'Cont.' setting
(Continuous) means that the device will continue dehumi-
dification without being shut down by the hygrostat.
The "OFF" setting means that the contact of the moisture
meter is open and that the device is not operational. Cau-
tion - whenever the mains plug is connected the electrical
components in the device are live.
37