Configuration / Initial Operation - Storch ProCut Bedienungsanleitung

A regular and careful cleaning and maintenance
schedule is required to ensure trouble-free operation.
The transformer must always be discon-
nected from the mains during troubleshoo-
ting measures.
Remove the mains plug!
If the wire does not get hot, check the 230 V power
supply. Check or replace the transformer fuse (item
No. 570004).
If doing this does not resolve the malfunction, con-
tact the STORCH service department or one of the
STORCH service centres in your area. Do not attempt
to repair the transformer yourself and do not replace
it with a type not approved by STORCH.
Other malfunctions that require the device to be re-
paired may only be performed by qualified STORCH
personnel or one of the authorised STORCH Service
Stations.
Guarantee, warranty, liability
We guarantee the flawless operation of the device
under the condition that it is duly operated and main-
tained. The warranty expires 1 year after the date of
purchase (billing date). It is restricted to material and
manufacturing defects. Additional claims and repla-
cement of wear and tear parts (e.g. cutting wire) are
excluded.
Any variations from the intended use will result in
expiration of the warranty.
The device must be deployed and operated in ac-
cordance with the conditions specified in this manu-
al. We shall not assume any liability or warranty for
damages resulting from non-compliance or improper
handling.
Personnel qualification
The device may only
missioned, operated,
aned by authorised,
Spare parts, consumables
All of the device components are available from
STORCH and its distribution partners. We recom-
mend that you keep sufficient quantities of the ori-
ginal cutting wire (item No. 570002) and fine wire
fuses (item No. 570004) in stock.
be assembled, com-
maintained and cle-
qualified personnel.
Device description / Initial operation of ProCut-
Front view
On/Off switch
11
Cutting bow with
depth gauge and
mitre aid 10
Slider for repeat
cuts
9
15
8
Bearing rail,
left
12
Device description / Initial operation of ProCut
Rear view
Locking bolt for
support leg 21
Transportation
lock and 20
cable holder

Configuration / initial operation

The device is delivered in a transport condition in its
transport case: Open the case and remove the de-
vice. Do not use the cutting bow to remove the de-
vice from the case. Grasp the device by the transport
handle (No. 2) in the wooden panel and remove it
from the case (Fig. 1).
36
Locking element
12
for cutting bow
Scale and locking ele-
13
ment for mitre cuts
Side profile for accommo-
14
dating the corner cutter
1
Base panel
2
Transport handle
3 Slider for repeat bevel
cuts
4
Bearing rail, right
5
Angle scale for
bevel cuts
Support for bea-
15
ring rail
6
Locking element for folding feet
7
Folding feet
Connecting box
16
for corner cutter
Support leg in
17
hinged position
Transformer
18
and cable
mount
Locking ele-
ment
19
for support
leg