Intended Use; Startup; Unpacking And Equipment Supplied; If You Detect Any Damage, Proceed As Directed In Kapitel - Sartorius PMA.Vision Installationsanleitung

Lay the cables where they pose no risk of
causing someone to trip.
Never close a paint can using a hammer while
it is still on the weighing pan.
When closing, place the paint can on a firm,
stable surface.
Observe the additional safety precautions and danger
descriptions in later chapters.

2.3 Intended Use

This scale is only intended for mixing paints and lacquers.
The scale is connected to the ex-link converter installed
outside of the potentially explosive area only using the link
cable supplied. The scale is used in potentially explosive areas
in Zone 1. Appropriate containers must be used for loading
each type of material.
The scale can be operated via the touch screen as a stand-
alone device or using a web application via a tablet,
smartphone or PC. The scale is connected to the ex-link
converter installed outside of the potentially explosive area
either via a network or directly via an Ethernet cable.

3 Startup

The scale must be disconnected from the power
supply for all assembly work.

3.1 Unpacking and Equipment Supplied

t
Open the packaging, making sure to remove all parts
carefully.
t
After unpacking the device, check it immediately for any
external damage.
t
If you detect any damage, proceed as directed in Kapitel „5
Care and Maintenance", Seite 11.
t
Save the box and all parts of the packaging for any
future transport.
All cables should be unplugged when transporting.
The following parts are included in the equipment supplied:
Model
Large weighing pan: d 233 mm
USB cable, 3 m
AC adapter YPS07-USB
Ex-link converter
Link cable from converter to scale
Installation Instructions
Vision
x
x
x
x
x

3.2 Selecting a Setup Location

Select the right setup location:
− Set up the device on a stable, even surface that is not
exposed to vibrations.
− Maintain free access to the device at all times.
Choose a location that is not subject to the following negative
influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, A/C systems, and doors
− Extreme vibrations during weighing
− Heavy traffic areas (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a
cold device when it is brought into a warmer area. You should
therefore let a device that has been disconnected from its
power source acclimatize for approximately 2 hours before
reconnecting it to the supply voltage.

3.3 Installing the Scale

Place the weighing pan on the
scale
t

3.4 Power Supply

The scale is connected to the power supply using
the AC adapter YPS07-USB (see Kapitel „7
Accessories", Seite 12), which is supplied with
mains adapters for use in various countries.
AC adapter assembly is described in the following.
Installation Instructions VIS1X
English
Place the weighing pan onto
the scale from above.
5