Sartorius Miras 2 Betriebsanleitung Seite 17

Setup Menu 1. Serial COM
2. Backlight
3. Auto Power Off
4. Standby Options
5. Adapter Filter
6. ADC Configuration
7. Reset Menu
• = Factory setting
1.1 Baud rate
1.2 Parity
1.3 Print option
2.1 On •
2.2 Off
3.1 No options •
3.2 5 Min.
3.3 10 Min.
3.4 15 Min.
4.1 On •
4.2 Off
5.1 Very stable conditions
5.2 Stable conditions •
5.3 Unstable conditions
5.4 Very unstable conditions
6.1 Decimal point
6.2 Basic unit
6.3 Step width
6.4 e<>d frame
6.5 Adjust FSD (span)
6.6 Calibration weight
6.7 Linearisation weight
6.8 Calibration unit
7.1 Do not restore
7.2 Restore
1.1.1 600
1.1.2 1,200
1.1.3 2,400
1.1.4 4,800
1.1.5 9,600 •
1.1.6 19,200
1.2.1 7-bit-None
1.2.2 7-bit-Odd
1.2.3 7-bit-Even •
1.2.4 8-bit-None
1.2.5 8-bit-Odd
1.2.6 8-bit-Even
1.3.1 Short •
1.3.2 Long/block
1.3.3 Continuous
6.1.1 0
6.1.2 1
6.1.3 2
6.1.4 3
6.1.5 4
6.2.1 g
6.2.2 kg
6.2.3 lb • For some countries,
6.2.4 oz these units
6.2.5 t are disabled
6.3.1 1
6.3.2 2
6.3.3 5
6.4.1 On
6.4.2 Off •
6.5.1 (Enter FSD weight)
6.6.1 (Enter CAL weight)
6.7.1 (Enter Lin weight)
6.8.1 g
6.8.2 kg •
6.8.3 lb
17