Operation In Combination With A Storage Tank - Palazzetti easytouch Anleitung

9.6 OPERATION IN COMBINATION WITH A STORAGE TANK

whether the storage tank is with or without a coil inside.
The boiler is controlled based on the temperature read by the probe in the storage tank.
When reaching the storage tank temperature set in the temperature menu
switches on again if the temperature falls below the delta set in submenu
OPERATION IN CONJUNCTION WITH THE "EVERSPRING" SYSTEM
Before using the product in combination with the "Everspring" system, read all the documentation supplied
with the system and ensure having received adequate instructions from the installer on operation of this
system and of any cooling units present.
The stove can operate in winter mode (default) or in summer mode, if the Everspring system also includes a
cooling unit.
Via the ventilation menu
9.6.1 Winter Mode
To switch from summer to winter mode, with the stove off (cold) but still connected to the mains:
a) Using the keys
b)
c) Press the key
the probe on the Everspring system (i.e. the boiler aims to maintain the desired temperature while minimising
consumption).
Where the user has enabled the "Eco-mode" function in the sub-menu [7] of the set-up menu
instead of modulating, will switch off when the temperature set is reached and switches back on again when the
It s possible to set the desired temperature in ambient in the temperature menu
[6]
In sub-menu
to set this temperature at around 70°C).
9.6.2 Summer Mode (to be used if there is a cooling unit combined with Everspring)
To switch to summer mode, with the stove off (cold), but connected to the mains, simply:
a) Using the keys
b)
c) Press the key
Set the desired summer temperature in ambient in the temperature menu
In this mode, the stove will activate the cooling unit when the ambient temperature exceeds the temperature set in
the temperature menu
[8]
in the sub of the set-up menu
After setting summer mode, to activate its operation, press the power key
48/13
USE AND & MAINTENANCE
, the user can change the speed of the hot/cold air through the Everspring unit.
navigate to the power menu
of the set-up menu it is possible to set the desired temperature of the supply water (it is advisable
navigate to the power menu
.
cod. 004772532 - 07/2018 - Palazzetti - PN - Italy
[8]
of the setup menu
and press the key ;
until a value of between 1 and 5 is reached;
and press the key ;
until the "SUN" value is reached;
.
the boiler switches off, and
.
, the boiler,
.
.
on the control panel.