Setting The Display Mode; Setting The Volume - Palazzetti easytouch Anleitung

8.3.2 Setting the display mode

The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"OFF" •
"1" •
"2" •
"3" •
•
"4"
e) Press
8.3.3 Setting the display brightnes
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set the desired brightness (

8.3.4 Setting the volume

The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu [
d) Set the desired volume (OFF, 1 to 5) using the
8.3.5 Setting the type of pellets
The type of pellets used can be set:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"1"
•
"2"
•
"3"
•
e) Press
46/13
USE AND & MAINTENANCE
to go to the setup menu
The display remains on the last operation set by the user;
All operating parameters are displayed cyclically;
The current time is shown
to go to the setup menu
OFF, 1 ... 5
to go to the setup menu
to go to the setup menu
Standard pellet (En Plus)
Long pellet
Small pellet
cod. 004772532 - 07/2018 - Palazzetti - PN - Italy
and then press
[12]
and press
and buttons:
and then press
[11]
and press
) using the buttons and press
and then press
13
] and press
buttons and press
and then press
[14]
and press
and buttons:
;
, If the function
;
;
;