Stove Operation; Switching Off - Palazzetti easytouch Anleitung

9 STOVE OPERATION

9.1 STARTING THE STOVE
Before every ignition, be sure that burning pot is completely empty and properly positioned in its seat.
To start the stove hold the
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
or drying of certain materials used. This phenomenon will gradually disappear.
9.2 MODIFYING THE PARAMETERS
power supply.

9.3 SWITCHING OFF

To switch the stove off hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched off following the procedure described above. Never switch the stove off by
unplugging it from the power supply.
9.4 OPERATION WITH ROOM THERMOSTAT
When the stove is controlled by an external thermostat (or timer thermostat), the installer must have set
output (that is, the stove attempts to maintain the desired temperature while minimising fuel consumption) when
reaching the set water temperature.
The stove switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
directly from the control panel.
The stove will go off automatically even in the case the water temperature keeps growing notwithstanding
the modulation mode. In this case the stove will ignite only if the difference between the selected and actual
temperature is over 20°C.
9.5 OPERATION WITH ROOM PROBE ON THE BOILER
The boiler can be switched on/off manually or in programmed mode.
on the boiler (that is, the boiler attempts to maintain the desired temperature while minimising fuel consumption).
If the user has enabled the "Eco-mode" function under submenu [7] of the setup menu
modulating its output, switches off when reaching the set temperature, and switches on again when the room
temperature falls below the delta set in submenu [7] of the setup menu
The desired room temperature can be set in temperature menu
6]
Submenu [ of the setup menu
for the heating system in question should be suggested by the heating system installer).
USE AND & MAINTENANCE
button for several seconds.
can be used to set the desired water outlet temperature (the best temperature
cod. 004772532 - 07/2018 - Palazzetti - PN - Italy
button), the stove needs to be started
, the boiler rather than
.
.
47/13