Palazzetti easytouch Anleitung Seite 39

6 INSTALLATION
6.1 LEVELLING THE STOVE
The stove must be levelled by adjusting the feet (where featured), then checked
using a spirit level (Fig. 6.1).
A B = Spirit level
6.2 SYSTEM CONNECTIONS
6.2.1 Electrical connection
The stove is connected to the electrical system simply using the plug supplied.
The electrical connection (plug) must be easily accessible when the stove is installed.
If the power cord is damaged it must be replaced by the technical service or a
6.2.1.1 Earth
accordance with legislation in force (Fig. 6.2).
6.2.2 Connection to an external timer thermostat
The stove can be connected to an external timer thermostat that switches the stove
on or off according to the set temperature.
When the set temperature is reached the thermostat opens the circuit and
consequently switches off the stove.
The external thermostat is connected to the two terminals on the rear of the stove,
which are jumpered in the factory. Disconnect the jumper and connect the two
thermostat contacts.
while the timer thermostat is in "call" status. This operation is also required in the
event of power failures or if the stove is switched off manually.
To avoid overlapping the working time bands, it's recommend to disable (set to OFF)
the stove's timer (see par. 10.1).
6.2.3 Operation with room probe
In certain circumstances the stove may need to modulate operation based on the
6.3.
6.2.4 Connection to a storage tank with coil
coil.
In this case simply disconnect the external temperature probe from the stove and
6.2.5 Connection to a storage tank without coil
The stove can be used to maintain the temperature inside a storage tank without
coil.
In this case simply disconnect the external temperature probe from the stove and
INSTALLATION
1 following the instructions shown in the
2 following the instructions shown in paragraph
4 following the instructions shown in paragraph 6.3.
cod. 004772532 - 07/2018 - Palazzetti - PN - Italy
Fig. 6.1
Fig. 6.2
39/13