Installation Site Preparation; General Information; Safety Precautions - Palazzetti easytouch Anleitung

5 INSTALLATION SITE
PREPARATION

5.1 GENERAL INFORMATION

The following paragraphs provide instructions that
must be complied with in order to ensure maximum
The following instructions are however subordinate
to compliance with any national, regional and local
laws and standards in force in the country where
the product is installed.

5.2 SAFETY PRECAUTIONS

Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
suitable load-bearing capacity.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
to request work to be performed by qualified
technicians.
Before having work performed by other technical
personnel verify their effective technical
competence. Before starting to assemble or
dismantle the stove, the installer must heed the
A) do not work in adverse conditions;
working and make sure that personal protective
equipment is in perfectly working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
INSTALLATION
cod. 004772532 - 07/2018 - Palazzetti - PN - Italy
5.3 STOVE INSTALLATION SITE
The enclosed "Product technical details" show the
minimum clearances from combustible materials
and objects expressed in centimetres that must
be observed when positioning the stove; for non-
halved.
to excessive heat.
wood, parquet, linoleum, laminates or carpets
base underneath stove. Such base may be made
from steel, slate, glass or stone and must cover the
attachment, and must extend at least 50 cm at the
front.
The manufacturer declines all liability for any
alterations to the characteristics of the material
Any elements made from wood (e.g. beams) or
other combustible material located near the stove
Leave enough clearance for maintenance work.
materials (x) is observed, as shown on the pipes
Pi = Combustible wall
Pp = Floor protection
Pp
Pi
Fig. 5.2
35/13