Attaching / Removing The Suction Nozzles; Removing / Inserting The Collecting Container; Use - Cleanmaxx PC-P003W Gebrauchsanleitung

Attaching / Removing the Suction Nozzles

j

Removing / Inserting the Collecting Container

Use

CAUTION!
■ Never hold the nozzles close to parts of your body or animals during use and do
not place your hands inside the nozzles. They could become stuck to the device/
injured. Should the cordless vacuum cleaner become stuck, switch the device off
immediately.
■ Switch on the device only once you have ensured that the suction nozzle, the
collecting container, the insert and the fi lter have been inserted correctly.
■ Always switch the device off fi rst before you replace a nozzle or attach or remove
any other accessories!
■ On no account should the device be used to suck up the following:
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
■ Empty and clean the collecting container after every use or when the maximum fi ll
level (marking) is reached during use (see the "Cleaning the Device and Accessories"
chapter).
23
• Plug the nozzle you want as far as it will go into the suction
opening on the front of the collecting container and check
that it fi ts securely. The locking latch of the window nozzle
must be heard to lock into place.
• To remove a suction nozzle, pull it out of the suction
opening. In the case of the window nozzle, the release
button (j) must be pressed at the same time.
• Removing: Hold the device with the collecting container
pointing downwards. Press the button for releasing the
collecting container and remove the main unit from the
collecting container.
• Inserting: On the bottom edge of the main unit there is
a locking lug. Plug this into the associated slot in the
collecting container. Then press the two parts of the device
together at the top until the locking mechanism is heard
to lock in place. It may be necessary to press the release
button here. Then check whether the collecting container
is fi tted in place properly.
■ IMPORTANT: If there is liquid in the collecting container,
do not overfi ll it or do not turn the device over with the
top pointing downwards so that no water can get into the
rectangular ventilation opening in the insert, and thus to
the motor!
EN