Troubleshooting - Cleanmaxx HS101 Gebrauchsanleitung

• Never touch the device, the cable or the plug with wet hands.
• The steam cleaner should be descaled with a standard commercial descaling agent
roughly every 6 months in order to extend the useful life of the steam cleaner. Also
note the manufacturer's instructions on the packaging of the descaling agent.
• Do not use corrosive or abrasive cleaning agents or cleaning pads for cleaning.
These can damage the surface.
• Empty the water reservoir (see the "Putting Into Operation" chapter, "Adding/Remov-
ing Water" section).
• If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
dry it with a soft cloth.
• Clean the attachments if necessary with clear, warm water.
• Allow all device and accessory parts to dry completely before you store them in a
clean and dry place that is inaccessible to children.

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct the
problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
Water emerges
from the attach-
ment.
The device does
not work. The
control lamp
does not light up.
No steam is
produced.
Streaks when
cleaning win-
dows or other
smooth surfaces.
Possible cause/solution
• The device has not yet reached operating temperature. Wait
until the control lamp has gone out.
• Water may emerge from the attachment when you fi rst start using
it. This is normal and does not constitute a defect with the device.
• Is the mains plug correctly inserted into the socket?
• Is the socket defective? Try a different socket and check the
fuse of your mains connection.
• Is the water reservoir fi lled with water?
• The device has not yet reached operating temperature. Wait
until the control lamp has gone out.
• The pipe of the device is not yet completely fi lled with steam.
Press the steam trigger several times until steam emerges.
• Is the attachment clogged?
• Has the safeguard been activated? Push in the securing pin to
release the safeguard.
• Is the scraper lip dirty? Wipe it clean.
• Is the scraper lip worn? Turn it over: Pull the rubber piece side-
ways out of its holder, moisten with water or cleaning agent in the
rounded area and slide back into the holder the other way round.
If after turning the rubber piece over both edges are worn, a
new rubber piece is required. (Spare parts can be ordered via
our website: www.service-shopping.de)
25 EN