Cleaning And Storage - Cleanmaxx HS101 Gebrauchsanleitung

EN
• The device has a a safeguard which blocks the steam trigger so that it cannot
be pressed accidentally. To (de)activate the safeguard, push in the securing pin.
• Water may emerge from the attachment when you fi rst start using it. This is
normal and does not constitute a defect with the device.
• As the pipe in the device has to refi ll with steam each time you use it, you
may need to press the steam release button several times when you start
using it before steam starts emerging.
• How much steam is emitted depends mainly on the speed and frequency
with which the steam release button is pressed. The faster you press the
release button, the more steam is emitted. However, this is at the expense
of the temperature. You should therefore only press the steam release but-
ton every 1-2 seconds to ensure that the steam is hot enough.
• If you want to steam-press clothing, use the wide nozzle with the cleaning
cloth and hang the clothing on a coat hanger beforehand.
1. If you have not already done so, fi t the attachment of your choice (see the "Putting
Into Operation" chapter, "Attaching/Removing Attachments" section) and pour water
into the water reservoir (see the "Putting Into Operation" chapter, "Adding/Removing
Water" section).
2. Insert the mains plug into a properly installed mains socket. The control lamp starts
to light up and the device starts to heat up.
3. The control lamp goes out after a few minutes. The device is now ready for use.
4. Move the attachment over the surface which is to be cleaned and press the steam
release button to release steam.
If the steam trigger cannot be pressed, the safeguard (13) has probably
been activated. Push in the securing pin to release the safeguard.
5. If you want to top up the water during use, pull out the mains plug and allow the de-
vice to cool down completely.
6. Then pour water into the water reservoir (see the "Putting Into Operation" chapter,
"Adding/Removing Water" section).
7. Remove the plug from the mains socket after use and allow the device to cool down
completely. Unscrew the water reservoir cap a little so that the pressure can escape.
Only fully unscrew the water reservoir cap once the pressure has been released and
empty the water reservoir (see the "Putting Into Operation" chapter, "Adding/Remov-
ing Water" section).
8. Clean the device if necessary and store it in a dry, clean place that is not accessible
to children (see the "Cleaning and Storage" chapter).

Cleaning and Storage

CAUTION!
• Remove the mains plug from the socket before cleaning the device.
• Shortly after use, the device may still be very hot. You should therefore wait a few
minutes until it has completely cooled down before you remove the attachment used,
empty the water reservoir and/or store the device away.
• Never immerse the device in water or other liquids!
24