Troubleshooting; Possible Cause; Technical Data - Cleanmaxx Z 06120 Gebrauchsanleitung

Troubleshooting

Problem
No steam emits.
Water emits instead
of steam.
Steam emits during
refill.

Technical data

Model number:
Voltage supply:
Protection class/level:
Capacity:
06120_DE-GB-FR-NL_V1.indb 22

Possible cause

• The device is not connected
with a mains socket, it is not
yet warmed up, or the steam
trigger has not been pressed
during use.
• The water tank is empty.
The water is condensing in the
tube.
The device is still too hot.
SV-418
230 V/50 Hz/1500 W
I, IPX4
max. 750 ml
22
Solution
• Check whether the device is
connected with a mains socket.
The device must warm up for
approx. 60 seconds before it
is able to emit steam. Push the
steam trigger during use.
• Refill the water tank (see
section "Use").
Push the steam trigger until steam
emits. If applicable, place a cloth
under the adapter as water may
leak out.
If nevertheless water continues
to emit, release the steam trigger,
remove the plug from the mains
socket, allow the device to cool
down for 5 minutes, and try it
again.
Allow the device to cool down
completely before refilling water.
23.02.10 09:26