Troubleshooting; Technical Data; Disposal - Cleanmaxx JC-210 Gebrauchsanleitung

Troubleshooting

If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst. Otherwise contact customer service. Do not attempt to repair a
defective device yourself!
Problem
No steam is emit-
ted. The control
light does not
illuminate.

Technical data

Model:
Product number:
Voltage supply:
Output:
Safety class:

Disposal

The packaging material is recyclable. Dispose of the packaging in an environ-
Customer service / importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.
Downloaded from www.Manualslib.com
Potential cause/solution
• Is the On/Off switch set to the I position?
• Is the mains plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• Has the device reached the operating temperature?
The device must heat up for approx. 30 seconds before it
begins to release steam.
• Is the water tank empty? Fill the water tank (see chapter
"Use", section "Filling the water tank").
• To emit steam, you must hold down one of the steam triggers.
mentally-friendly manner and make it available to the collection service for re-
cyclable materials.
Dispose of the device in an environmentally-friendly manner when you decide to
part with it. The device does not belong in the household waste. Dispose of it at
a recycling centre for old electrical and electronic devices. For more information,
please contact the administration in your community.
manuals search engine
JC-210
Z 2013
220 – 240 V ~ 50 Hz
approximately 1500 W
I
34