Spare Parts - FLAEM ELISIR Bedienungsanleitung

When used very frequently, we recommend that the nebuliser be replaced every 6 months (or earlier if it becomes
clogged), in order to guarantee the maximum therapeutic effect.
Unit and exterior of the tube
To clean use only a damp cloth and an antibacterial detergent (non-abrasive and solvent free).
• The casing of this unit is not protected against the penetration of liquids. Never wash the appliance under running
water or by soaking.
• Never submerge the unit in water; should this accidentally occur, unplug immediately. Do not remove or touch the
appliance under water before pulling out the plug. Take it immediately to an authorised service centre or your dealer.
RF6 PLUS NEBULISER DESCRIPTION
It is professional, quick and suitable for administering all types of drugs, including more costly ones, also in patients with
chronic diseases. It features a valve system that is automatically controlled by the patient's breathing. The configuration
of the internal lines of the RF6 PLUS nebuliser ensures the ideal granulometry providing effective treatment right down to
the lower airways.
INSPIRATORY PHASE
(A.)
(B.)
(.10.)
(.8.)
NON-SPILL SYSTEM
The RF6 PLUS nebuliser is specially suitable also for pediatric use, since the non-spill system prevents medication from
spilling out even if the nebuliser is accidentally turned upside-down.
AIR FILTERING
The unit is equipped with an air filter (.4.) which should be replaced when dirty or when its
colour changes. Do not wash or re-use the used filter. The filter must be regularly replaced to
help ensure efficient compressor performance. The filter should be regularly checked. For spare
filters contact your dealer or an authorised service centre.
To replace the filter:
Insert a flat screwdriver between the filter edge and the unit body. Lift the filter and remove it
by rotating and pulling it upwards. The filter is designed to remain fixed in its housing.
Use only Flaem's original accessories.

SPARE PARTS

Description
- RF6 PLUS nebuliser kit
- 1 m Connection tube
- PVC Adult mask
- PVC Child mask
- Spare Air filter kit per unit (n°2 pcs)
During the inspiratory phase, placing a finger over the hole of the
Nebulisation manual control causes compressed air to be introduced into
the nebuliser; at the same time the inspiratory valve (A.) of the nebuliser
opens to permit entry of an additional flow of air. The combination of
these air flows increases the quantity of medication nebulised and thus
assimilated by the patient (MAXIMUM ASSIMILATION OF MEDICATION).
During the whole inspiratory phase the expiratory valve (B.) remains
closed.
In the expiratory phase, removing the finger from the Nebulisation Manual
Control will cut off the flow of compressed air into the nebuliser and thus
interrupt the nebulisation of medication; at the same time the inspiratory
valve (A.) will close, preventing the nebulised mist from being discharged
from the nebuliser and dispersed in the surrounding environment
(MINIMUM WASTE OF MEDICATION). The air exhaled by the patient will
be released through the valve (B.), which opens automatically during the
expiratory phase while the mouthpiece remains in the mouth.
(Efficacy tested up to 5 ml, the average dose recommended for normal use)
6
EXPIRATORY PHASE
(B.)
(A.)
(.10.)
(.8.)
Code
ACO234P
ACO35
ACO79
ACO89
ACO164P