Cleaning And Maintenance - Ferm AGM1045 Originalbetriebsanleitung

mount the flange (7) using the flange key (8).
Mounting and removing the grinding disc
(fig. B)
Do not use the machine without the
guard.
Mounting
● Place the machine on a table with the guard
(4) facing upwards.
● Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
● Mount the grinding disc (9).
● Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Removing
● Place the machine on a table with the guard
(4) facing upwards.
● Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
● Remove the grinding disc (9).
● Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Mounting and removing the auxiliary grip
(fig. C)
Mounting
● Tighten the auxiliary grip (6) into one of the
mounting holes (13).
Removing
● Loosen the auxiliary grip (6) from the mounting
hole (13).
USE
Switching on and off (fig. A)
● This machine in equipped with a safety
switchand needs to be unlocked before
operation.
● Press at the bottom of the switch to unlock
theon/offswitch.
● Slide the on/off switch forwards.
● To switch off, depress the on/off switch, this
will then jump to the 'off' position.
● Do not put the machine down when the
motoris still running. Do not place the machine
on adusty surface. Dust particles may enter
themechanism.
8
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the grinding disc.
● Hold the machine with both hands.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the grinding disc on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the grinding disc against
the workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINtENANCE

Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Replacing the grinding disc (fig. B)
Worn or damaged grinding discs must be
replaced immediately.
Only use sharp and undamaged grinding
discs.
● To remove the old grinding disc (9), proceed
as described in the section
"Mounting and removing the grinding disc".
● To mount the new grinding disc (9), proceed
as described in the section
"Mounting and removing the grinding disc".
Carbon brushes
If the carbon brushes are worn, the carbon brushes
must be replaced by the customer service
department of the manufacturer or a similarly
qualified person.
wARRANty
Consult the enclosed warranty terms.